Hammer paint is applied on old paint, as it is compatible with almost all paints (alkyd, acrylic, urethane, silicone, etc.), except for materials on the basis of bitumen. To do this, fine wire brush to remove remaining particles of old paint and rinse the entire surface with a solution of detergent (or other detergent) to remove dust, dirt, small, fat and salt. Then rinse again with clean water and dried in the air. Paint 'Hemmerayt' is also suitable for coating metal plating. To do this, apply primer before painting For Galvanised Metal Surfaces. Painting doors and non-ferrous metals used first ground 'Hammerite Special Metal Primer'. At staining wood surfaces must first process the entire surface of the water-dilutable acrylic primer or primer firms 'Hemmerayt' 'Anti-Rust 1'. Do not apply paint 'Hemmerayt' right to the tree.

When stained welds need to be pre-primed 'Hammerite Special Metal Primer', and then apply paint 'Hemmerayt' by any method. Stage of surface preparation is given special attention because it is 90% successful at painting. Paint 'Hammerite' significantly different from all other known materials and their protective properties and, most importantly, set times. Paint 'Hammerite' dries quickly in air (20 – 30 minutes), but the cure is complete in 6 weeks (although the protective properties appear in 3 hours). Therefore, you must adhere strictly to the parameters and apply the paint. The paint is applied in several layers (depending on application method and the surface – from 2 to 5 layers). Each subsequent coat is applied after 20 – 30 minutes, but no later than 3:00, because after that begins the process of curing and the next layer can be applied not earlier than 6 weeks. Modes and parameters of the paint 'Hemmerayt' can be applied at temperatures between 10 C to 25 C, with humidity should not exceed 85%. The paint can be applied by spray, brush, roller, spray, air spray.